International Waters Community

International Waters Gallery


1858-rear.jpg
797 viewsInner side-profile plywood is 1.0 mm thick. All other surfaces is covered with 0.6 mm plywood. Divinycell H80 and CA glued with Zap green + kicker on plywood.Niklas Edlund
1859-rear.jpg
755 viewsDivinycell H80 used in this case. The lower ride surface has 1.5 deg angle.Niklas Edlund
1861-rears.jpg
665 viewsOne has the right top-view outline, one is marked...Niklas Edlund
1862-line.jpg
691 viewsSanding guide line.Niklas Edlund
1863-rear.jpg
664 viewsLower chamfer is sanded - ready for 0.6 mm plywood.Niklas Edlund
1864-rear.jpg
689 viewsSanded and ready for 0.6 mm ply...Niklas Edlund
1865-rear.jpg
793 viewsThe upper outer chamfered surface is sanded and ready to be covered. CA glue on foam + kicker on the plywood to be covered/added.Niklas Edlund
1866-rear.jpg
551 viewsThe last chamfered outer surface is covered with 0.6 mm plywood (O.6 mm = 0.023 inch).Niklas Edlund
1868-ready.jpg
694 viewsOne pair of Kep's 21 rear sonsons are ready. Total weight is about 10.3 gram each = about 0.36 oz. Do note, these are two right hand sponsons - not a pair... ;-)Niklas Edlund
 
9 files on 1 page(s)