International Waters Community

International Waters Gallery

Last additions - oldlugs
eaglet2.jpg
Eaglet So Far224 viewsPic shows the framework with the bottom skinned. Not sure yet if it'll handle the power of a modern .21... May go with a hot .12 in this one. Finished boat will be only 26.5" long.oldlugsMay 18, 2007
eaglet1.jpg
1976 Norco Eaglet Bottom (so far)213 viewsThis is a vintage Norco Eaglet I'm putting together. I picked up the unbuilt kit on eBay & traced all the parts to build one from fresh wood. The original kit wood was good stuff, but I didn't see any sense in using an unbuilt original kit, when I can just copy it. :) Pic shows hull bottom freshly skinned.oldlugsMay 18, 2007
AXERossi-Innotech-12-2.jpg
Converted L.Collari-Innotech .12204 viewsIt's really just a different flavor of AXE Rossi .12, sold by Innotech. The head was trimmed down, and a flywheel turned to fit the SG clutch type crank.oldlugsApr 17, 2007
AXERossi-Innotech-21-2.jpg
Converted XS400 buggy .21274 viewsIt's an L.Collari-Innotech XS400 buggy .21 engine, converted to marine with a Piranha/Niagara cooling jacket and flywheel turned to fit the SG style crank. L.Collari has used several engine manufacturers and vendors over the years to promote sales of product carrying his name... Innotech was one, but these engines were built by AXE Rossi. Specs look to be the same as the AXE Rossi "Black Magic", which was considered a very high torque .21 that still revved well.oldlugsApr 17, 2007
axerossifly1.jpg
Early AXE Rossi HTS .21 case has the forward mounting lugs.330 viewsI cut a couple of flywheels to clear the larger case and forward mounting lugs on this AXE Rossi. The later engines with this style case don't have these drilled, and they're ground down more.oldlugsApr 14, 2007
axerossifly3.jpg
Cut to fit AXE Rossi .21s with the extra mounting lug.179 viewsSince some AXE Rossi .21s have an oddball forward mounting lug, these needed to be cut a little shallower in the back.oldlugsApr 14, 2007
sgcrankfly1.jpg
SG crank flywheels.203 viewsoldlugsApr 14, 2007
sgcrankfly2.jpg
Flywheels cut to fit .21 car/buggy SG cranks.208 viewsA few different styles and weights to fit various SG crank .21s I have.oldlugsApr 14, 2007
flywheel3.jpg
206 viewsTaper and cone size the same as NovaRossi, but the flywheel's short enough for a piloted flex collet to grab plenty of threads. A 7mm chucking reamer bores the cone to fit snugly on the crank. Still need to trim the SG clutch shaft on this CMB/MAC buggy engine.oldlugsApr 05, 2007
flywheel2.jpg
178 viewsoldlugsApr 05, 2007
70 files on 7 page(s) 1