International Waters Community

International Waters Gallery


1001-lim.jpg
1069 viewsThe rear-most cut out done.Niklas Edlund
1002-cut.jpg
720 viewsThe radio compartment cut out is done. The underside will be reinforced and have a small lip for the lexan lid.Niklas Edlund
1003-lite.jpg
689 views2 mm lite-ply for the top deck radio compartment.Niklas Edlund
1004-kroppar.jpg
1324 views75% ready hulls - one with straight sides and one slim nosed. All cut-outs done. All made by dremel. First a cuting wheel and then sanding drums.Niklas Edlund
1005-cut.jpg
787 viewsTop view of top-deck trim.Niklas Edlund
1007-cut.jpg
800 viewsBulkhead #2. I have left about a 4 mm lip for holding down the cowl. The cowl will have a short lip to go underneeth the top deck here.Niklas Edlund
1008-lite.jpg
732 viewsLooking from the rear towards the front radio compartment bulkhead. The 2 mm lite-ply reinforcement/lid-lip has its edges beveled also on the underside.Niklas Edlund
1011-lite.jpg
760 viewsThe 2 mm lite-ply is cut-out to form a small lip edge for the lexan lid.Niklas Edlund
1012-cut.jpg
728 viewsThe rear top deck 2mm lite-ply reinforcement is trimmed flush with the deck edge.Niklas Edlund
1877-hole.jpg
785 viewsHole for the stuffing tube.Niklas Edlund
60 files on 6 page(s) 1