International Waters Community

International Waters Gallery

Click to view full size image

Side view of the entire assembly

If the base of the fixture is square, then the two bores (cylinder & crankshaft) must also be square to one another. If the dowel pin locations are the same distance from the center of both bores, on both bases, then the two bores are in line with each other also. Di-axis offset is easily set up with this fixture by moving the dowel pin location on the cylinder base.

crankcase, crankshaft, & piston fixtures 005.jpg crankcase, crankshaft, & piston fixtures 006.jpg crankcase, crankshaft, & piston fixtures 007.jpg crankcase, crankshaft, & piston fixtures 009.jpg crankcase, crankshaft, & piston fixtures 010.jpg
Rate this file (Current rating : 2.5 / 5 with 2 votes)