International Waters Community

International Waters Gallery

Click to view full size image

inside of the rear half of the dyno housing

The inside rear face of the dyno housing is stepped outward & fits precisely (.0001 clearance) inside the stepped inward front half. Notice the pockets; water inlet; barrel type water valve & the spring loaded graphite reinforced PTFE center shaft seal. A similar seal is used in the front housing half. No "o" ring is used to seal the dyno housing, only a very high finish on matting surfaces. There is no water leakage when operating the dyno!

dynamometer 030.jpg dynamometer 034.jpg dynamometer 035.jpg dynamometer 036.jpg dynamometer 039.jpg
Rate this file (No vote yet)