International Waters Community

International Waters Gallery

Click to view full size image

036 - shaft oilers

Just finished adding the Wood R/C shaft oilers. These are nicely done by Steve Wood and work extremely well especially in locations that don't give you enough room to remotely mount a sump like here on the Jag twin. I used the K&B angled brass water fittings to gain some extra clearance as the stock plastic right angle fitting was a little too close to the pipe. I briefly considered dropping the oiler bodies in the lathe and cutting them down a little but the K&B fitting wound up as the better choice here.

jag3build034.JPG jag3build035.JPG jag3build036.JPG jag3build037.JPG jag3build038.JPG
Rate this file (Current rating : 0 / 5 with 1 votes)